Note the image can get sharper and then softer again after a certain point. This would interfere with the process of light being reflected into the outside.Īfter this is done, turn your phone to an image and start adjusting the position of the foam board and phone to create a clear image. ![]() Make sure the hole is not enough to emit light into the box. The solution is to create a little tiny hole for a charger to go through. An average phone can hold battery for an average of 780mAh and 1200mAh.) This can be a stretch with some phones, especially if the battery is old. Step 5Īn additional thing you can do is create a tiny little hole on the side where your phone is. It would be quite annoying if you had to open up the box each time the screen goes black. Turn off your lock screen or any screen saver you might have. Set up your phone with the highest possible brightness. The preparation to the body is done, now for the technological part. This is used by using double sided padding tape on your phone and just taping your phone to the board. Cut out two small pieces of foam board and glue one in the middle of the face of the other one. The idea is that the phone must stay perpendicular to the ground to avoid distortion. All you have to do is create a phone stand in the shape of an upside down T. Position the lid back onto the box and mark where the lid and the projector interfere. This can be done on the inside of the box so it does not become aesthetically unpleasing.Īfter this is done, repeat the same concept onto the lid. After making sure the hole is just right, place the lens into position and glue the edge of it with a hot glue gun. Always mark something before gluing or cutting it. This tip goes for anything done in construction or DIY projects. Position your lens to mark where it will be later glued. A tip for perfectionists- if you want an exact circle, use an XACTO knife on the other end of a compass and cut out a perfectly symmetrical hole. Then, you must cut out a circular hole in place of the traced circle. Use a pencil to trace the circle where the lens will eventually go. Make sure to center it according to the face of the box. Leave like this for about fifteen minutes without interfering.Īfter dried, position the box upright and place the lens on the smaller side of the rectangular box. There is a good chance these pieces might want to come back out. ![]() Consider propping something on the edges you just glued. Do this with Elmer’s glue or any other universal glue. ![]() The next step is to secure the box from flapping by gluing any loose flaps or edges. This can be done with another tool as well, but it is not as effective unless it has sharp blades. First, use the hacksaw to remove the handle from the magnifying glass. After having instructed anyone inexperienced with the tools at hand, start on the project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |